120volt AC/DC transformer and a dimmer switch. Trying to run low voltage DC cable lights.? - low voltage track lighting
I have cable these lights, similar to track lights, but the lights are low voltage DC cables. I bought a 120-volt AC / DC 2.5-25AMP the transforming power of 500W them. I wanted to connect the processor to a rheostat so I can turn off the lights. The resistance, or a dimmer, according to the power connector.
I tried different types of switches, rheostat and fair.
The circuit is broken every time you try, the switch is actuated.
My guess is that the processor is not current?
12 / 2 wire is used in a dedicated 20 amp circuit transformer and has a minimum of 2.5 amperes and a maximum of 25 amps.
I went with the big transformer, because the distance between the two groups of light and distance from the DC supply.
Can the voltage regulator for the DC side?
When you switch on the DC side connected first?
Are there other options?
Thursday, December 24, 2009
Low Voltage Track Lighting 120volt AC/DC Transformer And A Dimmer Switch. Trying To Run Low Voltage DC Cable Lights.?
2 comments:
Because, as modern dimmer switches work, the processor is switched off and on twice in each cycle of alternating current. Each round, thereby increasing the processor is online. This is probably what triggered the circuit breaker.
It would be better served with a simple resistor / potentiometer on the DC side of the transformer. The controller functions only work with alternating current. Since we do not say what the voltage or current needs in the light of the cable is that you calculate the pot size you may need.
I think that can help the lighting of a local store. You can even have a transformer / inverter kit
You will need a regulator for DC, because they do not work on AC. Good luck.
Post a Comment